Electronic Product Design

Electronic Product Design in Penang, Malaysia

D3 Innovation (M) Sdn Bhd designs electronic hardware for OEMs in Bukit Mertajam, Penang, Malaysia: schematic design, PCB layout and design for manufacturability (DFM). Because we also build what we design, every layout is prepared for our own PCB assembly lines, so your product moves from concept to production without changing supplier.

Schematic design

We turn your product requirements into a circuit design, with attention to signal integrity, power distribution and component selection. Component choices are checked for availability through our network of electronic component brands, which reduces sourcing risk later in production.

• Requirements review and circuit architecture
• Schematic capture and component selection
• Design review before layout begins

PCB layout design

We lay out printed circuit boards using industry-standard tools such as Altium Designer and OrCAD, to IPC Class 2 or Class 3 requirements depending on your product.

• Multilayer PCB layouts
• Routing for high-speed signals and impedance control
• Thermal management
• Design for manufacturability (DFM) review for assembly on our SMT lines

From design to production

1. Requirements and NDA
2. Schematic design and component selection
3. PCB layout and DFM review
4. Prototype build and test (prototype orders accepted)
5. Production: PCBA, cable assembly, casings and box build, from 10 units

Need firmware as well? Embedded firmware is available through our software and firmware development service. For a complete design-and-manufacture project, see our ODM electronics design and manufacturing service; if your design is ready, see our EMS services.

Frequently asked questions

Which PCB design tools do you use?
Industry-standard tools such as Altium Designer and OrCAD.

What IPC class do you design to?
IPC Class 2 or Class 3, depending on the reliability your product needs.

Can you design multilayer boards with impedance control?
Yes. We handle multilayer layouts, high-speed routing and impedance control.

Can you also manufacture the boards you design?
Yes. D3 Innovation is an EMS and ODM manufacturer, so the same team takes your design into PCB assembly and box build in Penang.

How do I start a design project?
Email sales@d3innovation.com or call +604-526 8630 with your product requirements and target quantities.